|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
 ;
helpful manual.good service.Quick response.will use again
;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
1
Pull out the viewfinder.
Tripod Mounting
Bottom side of Power Grip
2 Set the Power Dial to �REC�. camcorder � The Power Lamp lights and the
enters the Record/Standby mode. � When the battery packs installed in the Power Grip become weak, the case�s Power Lamp begins to blink, and the lamp goes out when the battery packs have completely discharged. Replace them with two fully charged battery packs. � Be sure to set the Power Dial to "OFF" before installing charged battery packs. � While the DC Plug is connected, even as the battery packs begin to run down, the Battery Indicator on the camcorder will show the battery packs to be fully charged .
screw 1 Align the stud onand Power Grip the direction the tripod with Power Grip�s mounting socket and stud hole. Then tighten the screw.
� Refer to the tripod's instruction manual for details on mounting onto tripod.
EN-15
3 Press RECORDING START/STOP.
|
|
|
> |
|
