|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Happy to find finally a schematic for this amplifier. The schematic is of good quality, the pcb layout is useless: all is black. Never the less, it is very easy to find the components on the board using the schematics.
;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
NOTE: If the air filter is used when wet,suction is impaired and the motor may be damaged. *EXHAUST AIR FILTER(CV-80D, Fig.10,11) HYGIENIC AIR FILTER(CV-80DC, Fig.10,11)
Your vacuum cleaner has a highly efficient electrostatic exhaust air filter(64)(65) to trap even the finest dust particles in the exhaust air. Once or twice a year,when the filter gets dirty,change the filter as follows. 1. Open the front cover(62)(63). 2. Remove the old filter from the cleaner. 3. Fit a new filter in the cleaner.
Front cover
Fig.10
Air filter
*HEPA CLEAN FILTER(CV-80DP, Fig.12)
Your vacuum cleaner has a highly efficient electrostatic exhaust air filter(64) to trap even the finest dust particles in the exhaust air. Once or twice a year,when the filter gets dirty,change the filter as follows. 1. Open the front cover(62). 2. Remove the old filter from the cleaner . 3. Fit a new filter in the cleaner.
Fig.11
HEPA clean filter
Fig.12
5. FINAL TEST
(1) After reassemblage,run the cleaner for at least 15 minutes and be certain that there in no abnormal vibration. (2) Measure the insulation resistance between the power supply plug and the metal surface by 500V DC insulation resistance tester and be certain that the insulation resistance is not less than 10M ohms.
-6-
|
|
|
> |
|
