|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
;
The owners manual is very good. all my how to questions were answered in detail.
2
AIR CONDITIONER INSTALLATION
ACCESSORIES
(6 pcs) XTN5D25A (5 pcs) CWH4580211 (6 pcs) XTT4D10C
SELECT THE BEST LOCATION (Single or Double Window hung window)
Front grille 19�3/ inches
16
12 inches
NOTE Check that none of the accessories are missing.
SIDE VIEW CABINET INSTALLATION
More than 4 inches
WINDOW REQUIREMENTS � Hot sun rays hitting the outside surface of the cabinet will create considerable heat load. If the outside of the cabinet is exposed to direct sunlight, consider building an awning to 22 to 42-1/8� shade the cabinet while providing ample area for the heated air to be exhausted from the condenser (both sides) and the top. This unit is designed for installation in standard double hung windows. NOTE The unit may also be installed �through the wall�. You should, however, observe standard carpentry practices and frame the opening without violating local ordinances.
15
1 Cut the �Sealing Ribbon�
to the proper length, and attach it along the bottom edge of the bottom window sash.
Window sash sealing ribbon
15/16� (min)
2 To prevent condensation
water from dripping inside, the cabinet should be installed level or very slightly tilted to the outside.
3 Secure the cabinet using screws. Type A screw Inside of sash Top angle Expandable panel Window sill Type A screws Window sash foam seal Outside of sash Window sash Sealing ribbon
INSTALLATION PROCEDURES
Type B screws 1 Remove the rear cabinet screws and save for later use. 2 Slide the chassis out from the cabinet.
HOW TO ASSEMBLE THE EXPANDABLE PANELS
Top angle Top sealing ribbon (To be attached to the top angle) Type B screws
� Expand the expandable panel fully into the grooves of the window frame, secure the expandable panel, left, right and top mounting frames to the bottom of the window sash using 4 screws type A and 2 screws type B. � Secure the cabinet using wood screws type A. � Cut the window sash foam seal to the proper size and seal the opening between the top of the inside window sash and the outside window sash. NOTE If a gap exists between the unit and window sash, you may use �Sealer� supplied with the installation kit for a better seal. CHASSIS INSTALLATION INTO THE CABINET
Expandable panel Side sealing ribbon (To be attached to the expandable panel) Type C screws
1 Slide the chassis into the cabinet. 2 Reinstall the cabinet screws.
NOTE This procedure applies to left and right of assembling expandable panel.
Secure the cabinet to chassis by using screws (from rear cabinet).
� Attach the top angle to the cabinet using screw type B (3 pcs). � Insert expandable panels to cabinet sides as shown. � Secure the first fold of expansion panel to cabinet using screw type C (3 each).
|
|
|
> |
|
