|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good service-manual with clear electrical diagrams. Thanks you.
 ;
the manual is in quite good quality and it's in pdf. manual was send in less then 6h.
;
Absolutely top, I've got now all Service-Manuals I'll need to repair my Mackie-Mixer!
;
The service manuel is very helpful, we where able to restore the device to its working operation again.
;
Great quality complete service manual!!! complete parts list and drawings
EPSON AcuLaser CX11/CX11F
Revision A
REINSTALLATION 1. 2. 3. 4. 5. Put the IR SHAFT through the shaft hole of the CCD MODULE ASSY. Insert the right end of the IR SHAFT into the right bearing of the IR BASE ASSY, and then push the left end into the left bearing of the assy. See Figure 4-162. Move the CCD MODULE ASSY to the center. Attach the PULLEY ASSY to the IR BASE ASSY. Draw the FFC CR through the FFC CLIP, and turn the CCD MODULE ASSY upward upon the IR SHAFT and hold it to secure the FFC CLIP to the CCD MODULE ASSY with the two screws (M3 x 6 mm, B-type, P-head). See Figure 4-161. Connect the FFC CR to the connector on the CCD MODULE ASSY. Hitch the IR TIMING BELT to the gear of the MOTOR ASSY, and to the pulley of the PULLEY ASSY by sliding the PULLEY ASSY leftward. See Figure 4-160. Attach the IR COVER A ASSY. (p482) Attach the ADF Unit. (p481)
6. 7. 8. 9.
10. Install the Scanner. (p306)
DISASSEMBLY AND ASSEMBLY
Scanner Section
486
|
|
|
> |
|
