|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very professional seller; very fast, accurate and rielable service.
;
great works fine, got the manual on mail within a day
;
First class Service,
best quality, come again
Thank You.
vac
;
I didn't realise a manual for an early plasma TV such as the one we were gifted could be so easily obtained. No manual was supplied with it, and as senior citizens we were a little puzzled over some aspects of its use. I do not want a listing for your store credit as we are not fairly big computer users. The manual was well organised, as it should be, with its backing of the Pioneer name. The download was prompt and everything worked quite smoothly. Thank you. Gordon.
;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
CX-692
3. MECHANISM DESCRIPTIONS
- Inserting the Magazine
1. Inserting the magazine while countering the spring force of the EJECT lever , the lock arm will slide along the groove on the reverse side of the magazine and lock into place(due to the torsion spring on the reverse side of the lock arm).
2. The magazine lock is detected when the sensor arm moves along the EJECT lever cam section and presses against the MAG switch(S301) located on the CD core unit. Initially , the sensor arm is held by the cam section of the EJECT lever until the magazine lock arm is pushed off by the groove on the reverse side of the magazine. When the lock arm is pushed off the cam section is released , but is held again by the lock arm. When the magazine lock is released, the sensor arm presses the MAG switch(S301).
Fig. 29 When the magazine is not inserted EJECT lever cam MAG switch (S301) Detection arm When the magazine is not inserted
- Elevation Operation
The drive operation is the same as the CX-652. (See service manual CX-652:CRT1857)
- Elevation Detection
When the rear lever is driven the front lever and sensor lever are also driven via the jointed arm. The voltage is detected, and drive initiated, when the knob of the linear position sensor(slide volume:VR801) enters the U-shaped groove of the sensor lever. Stop Lock arm Moves along the groove in the magazine. Fig. 30
Stop
Fig. 31
24
|
|
|
> |
|
