This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
Text excerpt from page 21 (click to view)
Installation
Fitting the front facia panel / lightshield Dismantling
Disconnect the appliance from the electricity supply by unplugging at the socket, or removing the mains fuse. Take the dividing wall out of the wall unit. Release the hose clip from the exhaust connection and push the hose upwards. Screw the hinges (2) supplied to the left and right hand sides of the front facia panel / lightshield (1). With the Miele aluminium lightshield the screws are supplied. For lightshields with a Miele kitchen furniture programme use 3.5 x 16 mm ( 5/8 " ) screws supplied. Push the Allen screws from the accessory kit onto the cover caps until the screw heads lie directly under the holes in the cover caps. Hold the front facia panel / lightshield against the deflector plate: the holes in the hinges must lie over the holes visible in the deflector plate (3). Secure the cover caps an fascia panel / lightshield on both sides of the deflector plate using the Allen screws. Loosen the securing screws used to screw the cooker hood to the side walls. Pull the deflector plate out to its limit and remove the grease filters. Remove the screws now visible (DA 262 i / DA 272 i = 4; DA 292 i = 6) using a Philips screwdriver. Raise the cooker hood and then lower it to remove.
