|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Before you begin� Make sure that you have DARWIN connected to your mixer as described in the General Instructions section. DARWIN's eight outputs can be connected to eight inputs on your mixer. DARWIN's analog inputs can be connected to the channel outputs.
RECORDING
You probably already know how to record with DARWIN since it works just like a normal tape recorder.
Set the Input Routing
The Routing module determines which inputs are sent to what tracks. The analog sources are shown on the left side and the 8 track inputs are at the bottom of the window. The digital inputs and the mixdown sources are shown on the right side of the window (User setting only). In the example below, the 2-buss preset routing has been selected, which connects analog inputs 1 and 2 to all eight tracks. The connections between the inputs and tracks are represented by lines.
Input Pad Setting
Enable Tracks
1. While in the routing screen shown above, Press the Track Record Enable Buttons corresponding to the tracks you have just connected. In the example above, you could record enable tracks 1 and 2 (or 3 & 4, or 5 & 6, or 7 & 8, or all of them for that matter). Each pair is connected to analog inputs 1 & 2. The track record enable buttons will begin flashing when pressed and the corresponding peak meter above will reflect the signal level at the input.
Peak Meters
O -3 -6 -9 -12 -15 -20 -29 -36 -44
O -3 -6 -9 -12 -15 -20 -29 -36 -44
1
2
3
4
5
6
7
8
Track Enables
2 - Using DARWIN
21
|
|
|
> |
|
