ROLAND DB-900
Owner's Manual

The Memory Function
Calling Up Memory
1. Press the MEMORY A or MEMORY B button to choose the memory you want.
fig.004*

Storing the Panel Settings in Memory A and Memory B (Write)
You can store the settings for all controls except the MASTER knob in memory A or memory B. 1. When you�re done making the settings with the controls, press the WRITE button.
fig.006

� You can also choose a memory using the foot switch. When doing so, however, be aware that the MEMORY buttons do not function. � For more on the factory-default settings for memory A and memory B, see �Factory-default Settings� (p. 14).

2. Press the MEMORY A or MEMORY B button to choose memory A or memory B.
fig.004

Changing the Settings for Memory A and Memory B (Edit)
1. Press the MEMORY A or MEMORY B button to choose the memory whose settings you want to change.
fig.004*

� You can also choose a memory using the foot switch. When doing so, however, be aware that the MEMORY buttons do not function. � To cancel the Write procedure, press the MANUAL button. The Write procedure is then cancelled, and the DB-900 switches to Manual mode. You can also choose a memory using the foot switch. When doing so, however, be aware that the MEMORY buttons do not function. 2. Operate the controls. When a knob setting is changed, the selected MEMORY button flashes.
fig.005

3. Press the WRITE button to write (store) the settings to memory. The indicator flashes while writing is in progress, and remains steadily lit when it ends.
fig.007

When operating the controls, note that editing mode is actually entered after you�ve hit the same setting as the one in memory. This means it�s a good idea to give the control knob a big turn through all the possible settings, then bring it back to the setting you want.

If it is necessary to adjust the volume-level balance between memory A and memory B, adjust the VOLUME knob on the amplifier, and then store the settings.

NOTE
If the MANUAL button or a MEMORY button is pressed at this point, or the power is switched off, any changes you've made in the settings will be discarded. If you want to save the changes you've made, be sure to carry out the Write procedure.

12