|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
Note: Perform the operation in numerical order.
User's unit Operation 1 While pushing down RESET button, press then release RESET button. 4 Press . Display T? (Unit emits a buzz.)
Back up unit Operation 2 While pushing down RESET button, press then release RESET button. 3 Press . Display R? (Unit emits a buzz.)
T? (Unit emits a buzz.) END
R? (Unit emits a buzz.) END
5 After the data transmission.... It takes a few minutes to complete the data transfer.
6 When the data is transferred properly...... In case the data transfer ends incomplete......
NG! or
7 Press RESET button. 9 Press . USED Note: Never press as it deletes all the data. FREE
8 Press RESET button. 0 Press . USED Note: Never press as it deletes all the data. FREE
5250 60220
The above example is DC-8500RS display. The numbers vary depending on the quantity of data.
5250 60220
The above example is DC-8500RS display. The numbers vary depending on the quantity of data.
A Press
(OFF).
B Press
(OFF).
TROUBLESHOOTING
Before doing the following solutions, save data if possible.
SYMPTOM No power
CAUSE Weak battery Poor soldering of the power supply circuit
SOLUTION Replace batteries Resolder
No display at all or wrong display
Defective heat seal Defective LCD
Replace the heat seal Replace the LCD
�4�
|
|
|
> |
|
