|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
6) After setting the picture frame, if the [End] button is clicked, �5. Color Reproduction Adj.� is executed. The following message is displayed, and then adjust the burst position of the vectorscope.
7) If the [OK] button is clicked, the following message is displayed, and then adjust the luminance point of each color using the [Up]/[Down] button on the screen. After the adjustment finished, click the [End] button.
R-Y MG
R
YE B-Y
8) After the adjustment, if the [End] button is clicked, the following messages are displayed in the order given below. Then, change the chart in accordance with the message.
G
B
CY
Burst position
R-Y
Burst position
R
MG
YE B-Y G B
9) After the setting, if the [OK] button is clicked, the adjustment items �6. AWB Standard Data Input� and �7. LV Standard Data Input� are executed. 10) Upon successful completion of the �7. LV Standard Data Input�, the following message is displayed during the execution of �8. AWB Adj.�. During the execution, the following messages are displayed in the order given below. Place or remove the filters on the lens in accordance with the messages.
CY
Fig. 6-1-14
DCR-DVD92/DVD92E/DVD103/DVD602/DVD602E/DVD653/DVD653E
6-30
|
