|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Clear and complete service manual. Easy now to restore my old Kenwood KD-1500.
Thanks a lot.
;
Thanks for this "hard to find" service manual. This Sony PS212A is a very good turntable that needed to be restored !
 ;
Excellent quality on these manuals. Same as having the original printed manual and incredibly useful when doing a custom install like me. Keep it up on the good work.
;
This is an excellent information source. Great quality and tons of info regarding technical service for the Technics SH8065.
;
5 stars on this manual since it is the complete version, not the half manual you find free for download all over the web. Good job.
2-1-3. How to Set the Optical Sensor Disc 1) Fit a lug on the sensor side of optical sensor disc in the hole of the drive.
2-1-4. Precautions on Adjustment 1. Adjustment data The adjustment data for the drive block are recorded to the IC4403 on the VC-410 board. These data cannot be read or written from the adjustment remote commander or SeusCam, unlike the camera and LCD adjustment data. Accordingly, be sure to adjust all items of the drive adjustment when the following parts were replaced: � Drive block � Mounted VC-410 board � IC4101 (REC/PB RF amp.) on the VC-410 board. � IC4201 (Digital signal processor) on the VC-410 board. � IC4502 (Mecha drive) on the VC-410 board. 2. Order of adjustment Adjust the drive block in the following order: 1) POWER Adjustment 2) DVD-R Adjustment 3) DVD-RW Adjustment 4) DVD+RW Adjustment 3. Precaution on the laser diode
Fit a lug in the hole of drive.
Fig. 6-2-3
2) Push in the optical sensor disc until it clicks in the same manner as when setting a disc.
In the POWER Adjustment, operate the drive with the disc cover left open. During the adjustment, be sure to observe the following precautions: 1) Set the optical sensor disc correctly. 2) Keep the distance of more than 30 cm apart from the camcoder. 3) Work on the lens side of the camcoder (opposite side of the drive). Note: Laser light of the equipment is focused by the object lens in the optical pick-up so that the light focuses on the reflection surface of the disc Therefore, be sure to keep your eyes more then 30 cm apart from the object lens when you check the emission of laser diode
Pickup Lens (Laser Diode)
Fig. 6-2-4
Fig. 6-2-5
DCR-DVD7/DVD7E 6-41
|
|
|
> |
|
