SONY DCR-IP5
Owner's Manual

Superimposing a still image in a �Memory Stick� on a moving picture � MEMORY MIX
Before operation �Insert the tape you want to use for recording into your camcorder. �Insert the �Memory Stick� with still images recorded into your camcorder.

(1) Set the POWER switch to CAMERA. (2) In standby mode, select FN, then press the center z on the control button. The PAGE1 screen appears. (3) Select MEM MIX, then press the center z on the control button. The last recorded or last composed image appears on the lower part of the screen as a thumbnail image. (4) Select �/+ on the lower-right corner of the screen, then press the center z on the control button to select the still image which you want to superimpose. � : to see the previous image +: to see the next image (5) Select the desired mode, then press the center z on the control button. The still image is superimposed on the moving picture. (6) Select �/+ on the lower-left corner of the screen, then press the center z on the control button to adjust the effect. (7) Select OK, then press the center z on the control button. The PAGE1 screen appears. (8) Select EXIT, then press the center z on the control button. The FN screen appears. (9) Press START/STOP to start recording.

�Memory Stick� Operations

9 1
MEMORY/ NETWORK

POWER

CAMERA

(CHG) OFF ON

VCR

MODE

3
MEM MIX

MEM MIX

OFF MCCAM OVER� LUMI LAP

OK

CAMCM MCCAM CHROM CHROM

Still image
�
100�0001

+

2
FN

4,5
� +

MEM MIX

OFF

OK

M. LUMI

�

+

100�0001 � +

6
� +

MEM MIX

OFF

OK

M. LUMI

�

+

�

100�0001

+

133