|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality, prompt response. This website has reasonable prices and wide range of manuals that are hard to find.
;
The document was usefull, and it was exactly what I was looking for.
;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
DCR-IP5/IP5E/IP7BT/IP7E
SERVICE NOTE
1.
POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so that the unit cannot operate. These following two methods are available to prevent this. Take note of which to use during repairs. Method 1. Use the AC power adaptor (AC-L20, AC-VF50). Method 2. Connect the servicing remote commander RM-95 (J-6082-053-B) to the A/V jack, and set the commander switch to the �ADJ� side.
2.
1 2 3 4
TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
Refer to 2-2 to remove the cabinet (R) assembly. Disconnect CN2009 (31P, 0.3mm) of VC-263 board. Open the cassette lid. Supply +4.5V from the regulated power supply to the loading motor and unload with a pressing the cassette compartment.
Loading motor
CN2009 VC-263 board
Regulated power supply (+4.5Vdc)
�6�
|
|
|
> |
|
