|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
SERVICE NOTE
1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (4.2V), the power is shut off so that the unit cannot operate. This following two methods are available to prevent this. Take note of which to use during repairs. Method 1. Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the �ADJ� side. Method 2. Use the AC power adaptor (AC-VF10 or AC-VQ11) and connecting cord (DK-115).
B O
M A R R
2.
TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1 Refer to 2-2 to remove the accessory shoe and NS block assembly. 2 Refer to 2-2 to remove the jack ornamental plate. 3 Refer to 2-2 to remove the tripod screw. 4 Refer to 2-2 and 2-3 to remove the cabinet (R) block assembly. 5 Refer to 2-3 to remove the microphone unit. 6 Refer to 2-3 to remove the battery plate. 7 Refer to 2-3 to remove DD-125 board. 8 Refer to 2-3 and 2-4 to remove the cabinet (L) block assembly, lens block and EVF block. 9 Open MR-41 board. !º Disconnect CN2504 (4P, 0.8mm) of MR-41 board. !¡ Add +4.5V from the DC POWER SUPPLY and unload with a pressing the cassette compartment.
: Unloading : Loading
Disconnect from CN2504 of MR-41 board.
4D1
Loading motor
�6�
|
|
|
> |
|
