|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
DCR-PC330/PC330E
COVER
1-1. SERVICE NOTE
1. POWER SUPPLY DURING REPAIRS
SECTION 1 SERVICE NOTE
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so that the unit cannot operate. This following two methods are available to prevent this. Take note of which to use during repairs. Method 1. Use the AC power adaptor (AC-L15, AC-VQ800 etc.). Method 2. Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the �ADJ� side.
2.
1 2 3 4 5 6 7 8 9 q; qa
TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
Open the flash. (When the flash doesn�t open, refer to �3. HOW TO OPEN THE FLASH WHEN THE FLASH DOSEN�T OPEN�.) Refer to page 2-3 to remove the cabinet (F) section. Refer to page 2-3 to remove the cabinet (Rear) section. Refer to page2-4 to remove the cabinet (R) section. Refer to page2-11 to remove the EVF section. Refer to page2-13 to remove the stroboscope section. Refer to page2-15 to remove the lens section. Open the VC-325 board. Refer to page 2-19 to remove the VC-325 board and the mechanism deck. Disconnect CN2502 (27P, 0.3mm) of VC-325 board. Supply +4.5V from the DC power supply to the loading motor and unload with a pressing the cassette compartment.
Loading motor DC power supply (+ 4.5Vdc)
Disconnect the flexible board from CN2502 of VC-325 board.
CN2502
VC-325 board
3.
HOW TO OPEN THE FLASH WHEN THE FLASH DOSEN�T OPEN
1-1
|
|
|
> |
|
