|
There are currently no product reviews.
 ;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
3-1-3. Adjusting Connectors Some of the adjusting points of the video section are concentrated at VC-213 board CN910. Connect the measuring instruments via the CPC-13 jig (J-6082-443-A). The following table lists the pin numbers and signal names of CN910. Pin No. 1 2 3 4 5 6 7 8 9 10 Signal Name SWP AFC F0 BPF MONI RF AGC IN PB RF REG GND RF AGC OUT VC RF SWP EVF BL EVF BL 4.6V Pin No. 11 12 13 14 15 16 17 18 19 20 Signal Name EVF VCO EVF VG DV RF SWP RF IN CAP FG RF MON TMS TCK TDO TDI
CN910 1 20
Screw driver (�)
Table 5-3-1.
Cover
3-1-4. Connecting the Equipment Connect the measuring instruments as shown in Fig. 5-3-2 and perform the adjustments.
Connecting the TV Monitor and Regulated Power Supply
Battery terminal
Main Unit Regulated power supply 8.4 +0.1Vdc _ VIDEO
TV monitor
Connect when using the camera mode or playing back. VIDEO terminal
Fig. 5-3-2.
5-47
|
