|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I didn't realise a manual for an early plasma TV such as the one we were gifted could be so easily obtained. No manual was supplied with it, and as senior citizens we were a little puzzled over some aspects of its use. I do not want a listing for your store credit as we are not fairly big computer users. The manual was well organised, as it should be, with its backing of the Pioneer name. The download was prompt and everything worked quite smoothly. Thank you. Gordon.
;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
 ;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
;
Service manual very complete and clear. It was very helpfull for my work.
4-2. HCL Arm Assembly, Loading Motor Assembly
1. Removal procedure
1) 2) 3) 4) Hook the HC arm spring in the direction of the arrow B. Remove the HCL arm assembly 2 from the loading motor assembly 4. Remove the screw (M1.4 � 2.5) 3. Remove the three claws of the loading motor assembly 4 from the mechanism chassis assembly in the direction of the arrow A.
2. Attachment procedure
1) 2) 3) 4) Coat the worm shaft and gear of the loading motor assembly 4 with grease. Insert the three claws of the loading motor assembly 4 into the groove on the mechanism chassis assembly. Attach the screw (M1.4 � 2.5) 3. Tightening torque: 0.078 ± 0.01 N�m (0.8 ± 0.1 kgf�cm) Check the position of the HCL arm assembly 2 and the HC drive arm. Then attach the HCL arm assembly 2 to the loading motor assembly 4. Hook the HC arm spring 1 on the notch of the loading motor assembly 4. Clean the drum assembly. (Refer to section 2-1.)
5) 6)
Hook the HC arm spring on the notch of the loading motor assembly.
2 HCL arm assembly
Drive pin
3 Screw (M1.4 � 2.5)
Remove the loading motor assembly in the direction of the arrow A.
A polarity exists. The marked side has a red line.
4 Loading motor assembly
A
B
1 Pull and hook the HC arm spring in the direction of the arrow B.
Three claws Mechanical chassis assembly
When attaching it, coat the hatched portion with grease. Loading motor assembly (rear view)
Cover sheet Drive pin
HC drive arm
Loading motor assembly
Fig. 4-2.
� 15 �
|
|
|
> |
|
