|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
 ;
I liked the product. I would use their sevices again.
;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
DCR-TRV940/TRV940E/TRV950/TRV950E
1-3. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so that the unit cannot operate. These following two methods are available to prevent this. Take note of which to use during repairs. Method 1. Use the AC power adaptor (AC-L10, AC-VQ800 etc.). Method 2. Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the �ADJ� side.
1-4. TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1 2 3 4 5 6 7 Refer to 2-2 to remove the cabinet (R) block assembly. Refer to 2-7 to remove the F panel block. Refer to 2-11 to remove the battery panel block. Refer to 2-13 to remove the ST frame block. Refer to 2-14 to remove the DB-014 board. Refer to 2-15 to remove the MD block. Supply +4.5V from the DC power supply to the loading motor and unload with a pressing the cassette compartment.
DC power supply (+4.5Vdc)
: Unloading : Loading
Disconnect from CN1006 (27P) of VC-288 board
Loading motor
1-2
|
|
|
> |
|
