|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
It´s very very nice manual with all, what i need. Original in good quality. Very fast business. Very much thanks...
;
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site.
Thank you very much
;
Exactly what was needed to assess the product - excellent value and great service
;
A site where discontinualed schematic diagrams and back dated information can be found on discontinued radios tv's and any electronic equipment can be found. Newer manuals either Service and operating manuals. Radio amateurs should find this site a great source for ham radio equipment manuals. I will return to this site should I need information on any electrical equipment. priced easy to download in a PDF format and print pages need to undertake the repair.
;
Quality scan of the original. All the detail necessary to troubleshoot, repair and adjust the unit. I'm sure I will be downloading more manuals in the future as the need arises.
SERVICE MODE
4. Setting REGION code
4.1 While a highlighted indicator is displayed on the right side of the Region denotation, push ENT, and each button on the remote controller. With each push the indicator will advance as shown below.
Internal Setup Market 00 1 Region 1 Exit
00-WM 01-SFC 02-UK 03-XE 04-S18 05- SS 06-PA 07-AU 08-CN 09-JP 10-FXE 11-MX 13-NT
1 <-> 2 <-> 3 <-> 4 <-> 5 <-> 6
4.2 Specify the number of the model in accordance with the Market/Region Setup Table above. Region code of this mode is "1".
4.3 Once the desired number is displayed, push p button to move the highlighted indicator to Exit area.
(Reference figure)
5. Saving settings
5.1 Make sure that the Market and Region settings are properly set. (If any of the settings are incorrect, you can make a change by moving the indicator using o button, and following procedures 3 and 4 above. ) 5.2 After ensuring that the settings are all correct, push ENT button while the indicator is on Exit area. The settings are now saved.
Internal Setup Market Region 00 1
Exit
00-WM 01-SFC 02-UK 03-XE 04-S18 05- SS 06-PA 07-AU 08-CN 09-JP 10-FXE 11-MX 13-NT
(Reference figure)
6. Finishing settings
6.1 After a few seconds, the Internal Setup screen disappears, and then the Service Mode screen is displayed again for three seconds as shown on the right.
You should check the settings.
Region 1 Market WM BackendVersion S31204A2
S 31204 A 2
Backend version
Brand (S : SANYO , F : FISHER) Version ( 2 0 0 2 . 12 . 25) Sub Version (A,B,......Z) Region ( 0 : Region undefined 1 ~ 6 : Region defined ) Loader Version (17 Z09 Y03)
LoaderVersion
17 Z09 Y03
Value
(Reference figure) 6.2 Power OFF.
-4-
|
|
|
> |
|