|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
 ;
It paid to find this Service Manual, couldn't find it anywhere else. Exactly what I wanted. Received within 24 hours.
;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
FIRMWARE RENEWAL MODE
1. Turn the power on and remove the disc on the tray. 2. To put the DVD player into version up mode, press [9], [8], [7], [6], and [SEARCH MODE] buttons on the remote control unit in that order. The tray will open automatically. Fig. a appears on the screen and Fig. b appears on the VFD.
F/W Version Up Mode Please insert a DISC for F/W Version Up.
5. After programming is finished, the tray opens automatically. Fig. e appears on the screen and the checksum in (*3) of Fig. e appears on the VFD. (Fig. f)
F/W Version Up Mode VERSION : ******** Completed SUM : 7abc (*3)
Fig. e Completed Program Mode Screen
EXIT: POWER
Fig. a Version Up Mode Screen Fig. f VFD upon Finishing the Programming Mode (Example)
Fig. b VFD in Version Up Mode
The DVD player can also enter the version up mode with the tray open. In this case, Fig. a will be shown on the screen while the tray is open. 3. Load the disc for version up. 4. The DVD player enters the F/W version up mode automatically. Fig. c appears on the screen and Fig. d appears on the VFD.
F/W Version Up Mode VERSION : Reading...(*2) ********
At this time, no buttons are available. 6. Unplug the AC cord from the AC outlet. Then plug it again. 7. Turn the power on by pressing the power button and the tray will close. 8. Press [1], [2], [3], [4], and [DISPLAY] buttons on the remote control unit in that order. Fig. g appears on the screen.
model: ****** Ver: **** Region: **
1: VFD TEST 2: TT REPEAT PLAY 3: EEPROM CLEAR 4: MEASUREMENT SERVO 5: DISC READ CHECK 6: MECHA CHECK 7: DISC INFO 8: ERROR RATE RETURN: ----EXIT: POWER EXIT: POWER
Fig. g
Fig. c Programming Mode Screen
9. Press [3] button on the remote control unit. Fig. h appears on the screen.
model: ****** Ver: **** Region: **
Fig. d VFD in Programming Mode (Example)
TEST 3: EEPROM CLEAR EEPROM CLEAR: OK
The appearance shown in (*2) of Fig. c is described as follows:
No. 1 2 3 Appearance Reading... Erasing... State Sending files into the memory Erasing previous version data
RETURN: ----EXIT: POWER
Fig. h
Programming... Writing new version data
10.To finish this mode, press [POWER] button.
1-11-1
E5700TEST
|
|
|
> |
|
