|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality scan of the document. I am very pleased with what I got.
;
PDF Contains
Technical Data, Mechanical data, Detailed Circuit diagram with components value, PCB layout. Actual PCBs Print. Component List, Spare parts code list and Input output detail. It cover LBB1211, LBB1212, LBB1213, LBB1216, LBB1217.
It is the actual Service Manual for SQ10
;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
Service Manual CP-099F
3-5-7-4 The adjustment of H.bow - Apply PAL CROSS HATCH pattern. - Go to SERVICE MODE. - Press H.BOW or H.BOW key and "H.BOW" OSD will be displayed. - Adjust Parabola Width with H.BOW or H.BOW key. - In case of mass production in the factory, keeping the default value is recommended for the adjustment of H.bow Ddfault value : -00000 3-5-7-5 The adjustment of EW TRAPEZIUM - Apply PAL CROSS HATCH pattern. - Go to SERVICE MODE. - Press EW TRAPEZ or EW TRAPEZ key and "EW TRAPEZ" OSD will be displayed. - Adjust Parabola Width with EW TRAPEZ or EW TRAPEZ key. - In case of mass production in the factory, keeping the default value is recommended for the adjustment of EW TRAPEZ Ddfault value : +00060
3-6 The adjustment of RF AGC - Apply PAL signal of 60 2dB V of RF level. - Connect the probe of the oscilloscope to the P101 #3pin (TUNER AGC INPUT) - Go to SERVICE MODE. - Adjust with the COR-B UP/DOWN keys on the service remote control so that the DC voltage may have the value reducde by 1.0 0.2Vdc from - In case of mass production in the factory, keeping the default value is recommended for the adjustment of AGC Default value : 14 3-7 Setting the conditions for finished products - Go to SERVICE MODE. - Press the upper SHIPPING key on the SVC MODE REMOCON to set the conditions for the finished products. For the reference, the predesignated values are as follows. PICTURE SOUND NR BALANCE VOLUME NORMAL-1 NORMAL Off Center 21/63 Pr. Wake up Child Lock 01 Off Off
-14-
|
|
|
> |
|
