PIONEER DEH-2710/XU/EE
Owner's Manual

Section

04

Tuner

Listening to the radio

1

2

345

5 To perform seek tuning, press and hold c or d for about one second and release. The tuner will scan the frequencies until a broadcast strong enough for good reception is found.
# You can cancel seek tuning by briefly pressing either c or d. # If you press and hold c or d you can skip stations. Seek tuning starts as soon as you release the button.

1 Band indicator Shows which band the radio is tuned to, MW, LW or FM. 2 Frequency indicator Shows to which frequency the tuner is tuned. 3 LOC indicator Shows when local seek tuning is on. 4 Stereo (5) indicator Shows that the frequency selected is being broadcast in stereo. 5 Preset number indicator Shows which preset has been selected. 1 2 Press SOURCE to select the tuner. Use VOLUME to adjust the sound level.

Storing and recalling broadcast frequencies
If you press any of the preset tuning buttons 16 you can easily store up to six broadcast frequencies for later recall with the touch of a button. % When you find a frequency that you want to store in memory press one of preset tuning buttons 16 and hold until the preset number stops flashing. The number you have pressed will flash in the preset number indicator and then remain lit. The selected radio station frequency has been stored in memory. The next time you press the same preset tuning button the radio station frequency is recalled from memory.
Notes ! Up to 12 FM stations, 6 for each of the two FM bands, and 6 MW/LW stations can be stored in memory. ! You can also use a and b to recall radio station frequencies assigned to preset tuning buttons 16.

3 Press BAND to select a band. Press BAND until the desired band is displayed, F1, F2, F3 for FM or MW/LW.
F1: 65  74 MHz F2, F3: 87.5  108 MHz

! The FM bands cover different frequency ranges as below:

4 To perform manual tuning, briefly press c or d.

6

En