|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
HHHHHHHHHHHHHH Tuner
Section
04
Listening to the radio
4 To perform manual tuning, press c or d with quick presses. The frequencies move up or down step by step. 5 To perform seek tuning, press and hold c or d for about one second and release. The tuner will scan the frequencies until a broadcast strong enough for good reception is found.
English
1
23
4
These are the basic steps necessary to operate the radio. More advanced tuner operation is explained starting on the next page.
Important If you are using this unit in North, Central or South America, reset the AM tuning step (see Setting the AM tuning step on page 27).
# You can cancel seek tuning by pressing either c or d with a quick press. # If you press and hold c or d you can skip broadcasting stations. Seek tuning starts as soon as you release the buttons. Note When the frequency selected is being broadcast in stereo the stereo (5) indicator will light.
1 Band indicator Shows which band the radio is tuned to, AM or FM. 2 Frequency indicator Shows to which frequency the tuner is tuned. 3 Stereo (5) indicator Shows that the frequency selected is being broadcast in stereo. 4 Preset number indicator Shows what preset has been selected. 1 Press SOURCE to select the tuner. Press SOURCE until tuner is selected as the source. 2 Use VOLUME to adjust the sound level. Press to increase or decrease the volume. 3 Press BAND to select a band. Press BAND until the desired band is displayed, F1, F2, F3 for FM or AM.
En
9
|
|
|
> |
|
