PIONEER DEH-P2650/XIN/ES
Owner's Manual

Section

07

Audio Adjustments

3 Press c or d to select the desired frequency. Press c or d until the desired frequency appears in the display. Low: 4080100160 (Hz) Mid: 2005001k2k (Hz) High: 3k8k10k12k (Hz) 4 Press a or b to select the desired Q factor. Press a or b until the desired Q factor appears in the display. 2N1N1W2W
Note If you make adjustments when a curve other than CUSTOM is selected, the newly adjusted curve will replace the previous curve. Then a new curve with CUSTOM appears on the display while selecting the equalizer curve.

Note You can also turn loudness on or off by pressing LOUDNESS.

Front image enhancer (F.I.E.)

The F.I.E. (Front Image Enhancer) function is a simple method of enhancing front imaging by low-range frequencies. You can select the frequency you want to cut.
Precaution

cutting mid- and high-range frequency output from the rear speakers, limiting their output to

When the F.I.E. function is deactivated, the rear speakers output sound of all frequencies, not just bass sounds. Reduce the volume before disengaging F.I.E. to prevent a sudden increase in volume.

Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Press AUDIO to select LOUD. Press AUDIO until LOUD appears in the display. 2 Press a to turn loudness on. Loudness level (e.g., LOUD :MID) appears in the display. 3 Press c or d to select a desired level. Each press of c or d selects level in the following order: LOW (low)MID (mid)HI (high) 4 Press b to turn loudness off.

1 Press AUDIO to select FIE. Press AUDIO until FIE appears in the display. 2 Press a to turn F.I.E. on.

# To turn F.I.E. off, press b.

3 Press c or d to select a desired frequency. Each press of c or d selects frequency in the following order: 100160250 (Hz)
Notes ! After turning the F.I.E. function on, use the balance adjustment (refer to page 22) and adjust front and rear speaker volume levels until they are balanced. ! Turn the F.I.E. function off when using a 2speaker system.

LOUD :OFF appears in the display.

24

En