|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
1
2
3
4
6.4 SYSTEM MICROCOMPUTER TEST PROGRAM
A
- PCL output
In the normal operation mode (with the detachable panel installed, the ACC switched ON, the standby mode cancelled), shift the TESTIN IC601 (Pin 86) terminal to H. The clock signal is output from the PCL terminal IC601 (Pin 37). The frequency of the clock signal is 468.75 kHz that is one 32th of the fundamental frequency. The clock signal should be 468.75 kHz ± 19 Hz. If the clock signal is out of the range, the X'tal (X601) should be replaced with new one.
B
6.5 OEL ADJUSTMENT
Adjustment point
KEYBOARD UNIT(SIDE B)
C
TP1 TP3 TP2
D
Digital Multi-Meter
<When the OEL Unit has been replaced> 1. Use VR1970 to adjust the resistance between TP1 and TP3 to 6.2 k�. 2. Use VR1971 to adjust the resistance between TP2 and TP3 to 6.2 k�.
E
F
52
DEH-P580MP/XN/UC
1 2 3 4
|
|
|
> |
|
