|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Section
02
Operating this unit
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q factor (curve characteristics) of each currently selected curve band (EQ-LOW/EQ-MID/ EQ-HIGH).
Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. 1 Press SW to select SUBWOOFER.
# You can also select the subwoofer setting menu by pressing AUDIO on the unit.
Level (dB) Q=2N Center frequency Frequency (Hz) Q=2W
2 Press a to turn subwoofer output on. SUBWOOFER NOR appears in the display. Subwoofer output is now on.
# If the subwoofer output phase has been set to the reverse, SUBWOOFER REV will be displayed. # To turn subwoofer output off, press b.
1 Press AUDIO and hold until frequency and the Q factor (e.g., F-80 Q-1W) appears in the display. 2 Press AUDIO to select the band for adjustment from among low, mid and high. 3 Press c or d to select the desired frequency. Low: 40�80�100�160 (Hz) Mid: 200�500�1k�2k (Hz) High: 3k�8k�10k�12k (Hz) 4 Press a or b to select the desired Q factor. 2W�1W�1N�2N
Note If you make adjustments, CUSTOM curve is updated.
3 Press c or d to select the phase of subwoofer output. Press c to select reverse phase and REV appears in the display. Press d to select normal phase and NOR appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Press SW to select SUBWOOFER.
# You can also select the subwoofer setting menu by pressing AUDIO on the unit. # When the subwoofer output is on, you can select SUBWOOFER (subwoofer setting).
Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Press AUDIO to select LOUDNESS.
2 Press c or d to select cut-off frequency. 50�63�80�100�125 (Hz) Only frequencies lower than those in the selected range are outputted from the subwoofer. 3 Press a or b to adjust the output level of the subwoofer. +6 to �24 is displayed as the level is increased or decreased.
2 Press a to turn loudness on. Loudness level (e.g., LOUDNESS MID) appears in the display.
# To turn loudness off, press b.
3 Press c or d to select a desired level. LOW (low)�MID (mid)�HIGH (high)
18
En
|
|
|
> |
|
