|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Audio Adjustment
Subwoofer Setting Adjustment (Sub-W2)
When the Subwoofer output is ON, you can adjust the cut-off frequency and the output level of Subwoofer.
1. Press the AUDIO button and select the Subwoofer setting mode (Sub-W2) in the Audio Menu. 2. Select the frequency to 50 Hz, 80 Hz or 125 Hz with the 2/3 buttons. 3. Increase or decrease the output level with the 5/� buttons.
The display shows �+ 6� � �� 6�. Note:
� You can select the Subwoofer setting mode only when Subwoofer output is switched ON in the Subwoofer ON/OFF mode.
Non Fading Output (NonFad)
When the Non Fading Output setting is ON, the audio signal does not pass through this unit�s low pass filter (for the Subwoofer), but is output through the RCA output. Note:
� When the Subwoofer Controller setting is only �S.W Control:EXT�, you can switch the Non Fading Output ON/OFF mode. (Refer to page 52.)
1. Press the AUDIO button and select the Non Fading Output ON/OFF mode (NonFad) in the Audio Menu. 2. Switch the Non Fading output ON/OFF with the 5/� buttons.
43
|
|
|
> |
|
