|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
Audio Adjustment
Subwoofer Setting Adjustment (Sub-W2)
When the Subwoofer output is ON, you can adjust the cut-off frequency and the output level of Subwoofer.
1. Press the AUDIO button and select the Subwoofer setting mode (Sub-W2) in the Audio Menu. 2. Select the frequency to 50 Hz, 80 Hz or 125 Hz with the 2/3 buttons. 3. Increase or decrease the output level with the 5/� buttons.
The display shows �+ 6� � �� 6�. Note:
� You can select the Subwoofer setting mode only when Subwoofer output is switched ON in the Subwoofer ON/OFF mode.
Non Fading Output (NonFad)
When the Non Fading Output setting is ON, the audio signal does not pass through this unit�s low pass filter (for the Subwoofer), but is output through the RCA output. Note:
� When the Subwoofer Controller setting is only �S.W Control:EXT�, you can switch the Non Fading Output ON/OFF mode. (Refer to page 52.)
1. Press the AUDIO button and select the Non Fading Output ON/OFF mode (NonFad) in the Audio Menu. 2. Switch the Non Fading output ON/OFF with the 5/� buttons.
43
|
|
|
> |
|
