|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Section
11
Audio Adjustments
# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.
�12� �6�Pass (0) (dB/oct.)
3 Turn MULTI-CONTROL to select Rear HPF FREQ. Rear HPF FREQ. appears in the display. 4 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50�63�80�100�125�160�200 (Hz) Only frequencies higher than those in the selected range are output from the rear speakers. 5 Push MULTI-CONTROL up or down to adjust the output level of the rear speakers. Each time MULTI-CONTROL is pushed up or down, the level of the rear speakers increases or decreases. 0 to �24 is displayed as the level is increased or decreased.
3 Turn MULTI-CONTROL to select Front HPF FREQ. Front HPF FREQ. appears in the display. 4 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50�63�80�100�125�160�200 (Hz) Only frequencies higher than those in the selected range are output from the front speakers. 5 Push MULTI-CONTROL up or down to adjust the output level of the front speakers. Each time MULTI-CONTROL is pushed up or down, the level of the front speakers increases or decreases. 0 to �24 is displayed as the level is increased or decreased.
Using the auto-equalizer
The auto-equalizer is the equalizer curve created by auto TA and EQ (refer to Auto TA and EQ (auto-time alignment and auto-equalizing) on page 56). You can turn the auto-equalizer on or off. 1 Use MULTI-CONTROL to select Auto EQ. Auto EQ appears in the display.
# Please set Auto EQ appears. This indicates that you cannot turn the auto-equalizer on if auto TA and EQ has not been carried out.
Setting the high pass filter for rear speakers
1 Use MULTI-CONTROL to select Rear HPF. Rear HPF appears in the display. 2 Push MULTI-CONTROL left or right to select slope. Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order: �12� �6�Pass (0) (dB/oct.)
2 Press MULTI-CONTROL to turn the autoequalizer on. ON appears in the display.
# To turn auto-equalizer off, press MULTI-CONTROL again.
# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.
52
En
|
|
|
> |
|
