|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
 ;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
;
reasonable price for the schematic - the service is perfect, all as expected and pointed by instructions - good scan of the original plans - thank you!
5
6
7
8
A
In a case when no image from any input appears
� Reset discharge is occurred. � Mask is displayed. � DSD is not displayed. YES Examination of the MAIN board YES Is the voltage at Pin 51 of IC8501 3.3 V DC? NO Disconnect the cable from the PN1 connector. Check if 3.3V DC is output from Pin 1 of PN1. YES YES Waveform 33 Failure in the MAIN PWB NO Failure in the power supply unit, or PN1 cable broken
B
NO
Diagnosis of Panel Module
Is a CLK signal input to Pin 12 of IC8501? And are sync signals input to Pins 55 and 57? Is a DE signal input to Pin 58?
YES
Failure in the IC8501
C
NO Is the voltage at Pin 1 of PN2 connector 2.5 V DC? NO Disconnect the cable from the PN2 connector. Check if 2.5V DC is output from Pin 1 of PN2. YES YES Is the voltage at Pin 4 of IC8002 1.5 V DC? YES Is the voltage at Pin 5 of IC8003 1.5 V DC? YES NO Failure in the IC8003 NO Failure in the MAIN PWB NO Failure in the power supply unit, or PN2 cable broken
Failure in the IC8002
D
Waveform 34 NO Failure in the X8001
Is a CLK signal input to Pin 3 of X8001? YES of X8002? YES Failure in the MAIN PWB
Waveform 35 NO
E
Is a CLK signal input to Pin 3
Failure in the X8002
F
PDP-425CMX
5 6 7 8
147
|
|
|
> |
|
