|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
 ;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
5-2.
Installation to the Projector
5-2-1. Installing to CENTURY JJ (Strong International)
Required Parts
Notes on Installation . Place the DFP-R3000 in the upright position (not sideways nor tilted) and position the reader (part of the drum where the LEDs are located) of the DFP-R3000 more than 24 frames but within 119 frames from the picture gate of the projector. However the film speed must be stable (within ± 5 %) when the first image frame passes by the reader of the DFP-R3000. . The tension of the film that is supplied to the DFPR3000 during film running is set to 0.5 to 59 N (50 to 600 fg). Adjust so that the tension is within the above range between the beginning and end of the supplied film. Required Tools Path adjustment tool (Sony part No. J-6510-220-A) 35 mm Film Phillips screwdriver Nut driver (d = 5 mm) Hexagon screwdriver (across ; 3 mm)
Adapter (A) ; 1 (Supplied with DFP-R3000) Hexagon cap screw (3/8-16) ; 2 (Supplied with DFP-R3000) Wave washer ; 2 (Supplied with DFP-R3000) Screw (PSW4 x 12) ; 4 (Supplied with DFP-R3000) Procedure
Step 1. Installing the Adapter (A) to the Projector
1. Remove REEL ARM or platter guide roller of supply reel side of the projector. 2. Attach the adapter (A) tentatively to the projector using the two hexagon cap screws (3/8-16) 1 and wave washers. n Fixing hole of adapter (A) varies depending on the projector to be used. (See the figure below.) 3. Attach the path adjustment tool tentatively to the adapter (A) with the screws (PSW4 x 12) 2 as shown in the figure.
Path adjustment tool
1 Hexagon cap screw (3/8-16) Wave washer
1
PSW4 x 12 2
Adapter (A) 2 PSW4 x 12 Projector CENTURY JJ
DFP-R3000
1-7 (E)
|
|
|
> |
|
