|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
4-16. Tape Path Alignment 4-16-2. Tape Path Check and Adjustment
S1 guide: The tape runs without tape slack on the upper side of the guide. S2 guide: The tape is in contact with the upper flange of the guide but curls very little. S3 guide: The tape is in contact with the lower flange of the guide but curls very little. S4 guide (tension regulator guide): Even tape tension is applied to the tape.
Drum: The tape runs along the rabbet guide of drum without floating or off from the lead.
T1 guide: The tape runs without tape slack on the upper side of the guide. T2 guide: The tape is in contact with the upper flange of the guide but curls very little. T3 guide: The tape runs in the center of the upper and lower flanges. Capstan shaft (pinchpress mode): Be sure not to damage the tape by tape wrinkle when the pinch roller is pressed against the capstan shaft. T4 guide: The tape is in contact with the lower flange of the guide but curls very little. T5 guide: The tape is in contact with the lower flange of the guide but curls very little. T6 guide: The tape is in contact with the upper flange of the guide but curls very little.
E
S5 guide: The tape is in contact with the upper flange of the guide but curls very little. S6 guide: The tape is in contact with the upper flange of the guide but curls very little. S reel: The tape barely touches the reel flange while it is running.
T reel: The tape barely touches the reel flange while it is running.
Fig. 4-16-1. Tape Path Check
DIR-1000H USM
4-113
|
|
|
> |
|
