|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
SUSPENSION INSTALLATION AND ADJUSTMENT
13
Remove M5 retaining bolt from the suspension cover with wrench provided. Insert end of spring into suspension bar as diagram. Fit all 3 units. The Platter should now be leveled by adjusting each spring in turn. This is done by holding spring and turning foot as in diagram below. Move the feet so that the springs do not touch the adjusters lower body. The base of the suspension bars should be about 3 - 5mm from the top of foot. Once the motor and drive belt have been fitted readjustment may be required. The suspension will be correctly set when the drive hub is level with the drive pulley and the platter, subchassis and pick-up arm move in a smooth pistonic motion without any wobble. Once correctly set the suspension covers can be refitted so that the suspension bars do not touch.
14
15
16
13 14
6
|
|
|
> |
|
