|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
- CONTENTS/ACCESSORIES/CAUTIONS
- CONTROLS
- DISASSEMBLY FOR REPAIR
- BLOCK DIAGRAM
- CIRCUIT DESCRIPTION
- TROUBLESHOOTING
- ADJUSTMENT
- PC BOARD
- SCHEMATIC DIAGRAM
- EXPLODED VIEW
- PARTS LIST
- SPECIFICATIONS
There are currently no product reviews.
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
 ;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
DM-3090
TROUBLE SHOOTING
� Disc motor fails to run
Does waveform appear on the pins 24 and 25 of IC1201 in the TEST mode focus gain coarse adjustment step? Yes Does waveform appear on the pins 34 and 35 of IC1601, pins 1 and 2 of CNP1603? Yes Replace the completed disc motor. Check soldering joint of PWB of completed IC1601 and CNP1601 disc motor. No Check soldering joint and parts of pins 24 and 25 of IC1201, and peripheral circuit.
No
� Tracking servo failure
Does waveform appear on the pins 8 and 9 of IC1601, and pins 1 and 3 of CNS1101 in the TEST mode focus gain adjustment step? Yes Replace the optical pickup. No Check the soldering joint of pins 20 and 21 of IC1201, IC1601, IC1601, CNS1101.
� Slide servo failure
Does the pickup move to external and internal periphery when the or button is pressed in the TEST mode? No Is there any change on the pins 22 and 23 of IC1201 when the or button is pressed? Check the waveform on the pins 22 and 23 of IC1201, check the peripheral parts and soldering joint. Yes Check the waveform on the pins 22 and 23 of IC1201, check the peripheral parts and soldering joint.
No
Yes Is there any change on the pins 28 and 29 of IC1601, and the pins 1 and 2 of CNP1602 when the or button is pressed? Yes Does voltage on the positive and negative terminals of slide motor change when the or button is pressed? Yes Replace the slide motor. Check the soldering joint connected to the slide motor to see whether there is wire breakage. Check the soldering joint of IC1601 and CNP1602.
No
No
23
|
|
|
> |
|
