This is one of four manuals I have downloaded recently.
Purchase was very straight forward and the authorising email arrived in about 4 hours.
The quality of the scan is good. Print is clear and square to the page edges.
Having purchased a 1994 Kenwood music system from a Charity shop in 2013 (it was a high end product in its day), I found myself not quite knowing where to plug in what, and how to do this, that and the next thing. I needed a Manual, and after failure with another online 'Manual provider' I found Owner Manuals dot com. Well, I wasn't sure, but it was only $5, and if things didn't work out, I wouldn't have lost much...
But things DID work out. After paying my childrens inheritance money, $4.99, I was sent a Manual for my Kenwood System very quickly. Alas, it was in German, and being Scottish, I could not read it or get my system in order from it...a rapid email to them brought the English Manual in short order, and my retro-system was and IS up and running in it's regulation settings.
I am very grateful to http://www.owner-manuals.com for their quick service and for even having such an obsolete Manual in the first place! If you need a Manual for ANYTHING, try here first. I wouldn't be surprised if I bought a 1928 Marconi radio, and got the user Manual for THAT here too!
Top marks.
John Copeland
Glasgow
Scotland
Text excerpt from page 15 (click to view)
� Mark the wall with a centre line, this will aid mounting procedure (1), position the template so that the mid line printed on the template matches with the centre line previously signed, the lower side of the template corresponds to the lower side of the hood once mounted (2). � Drill two holes � 8mm and fix the support bracket with two wall plugs and screws (3). � Hang the hood (4) adjust its position (5-6) and from the inside of the hood mark one point for definitive fixing (7), remove the hood and drill a hole � 8mm (8), fit a wall plugs, hang the hood again and fix it definitively with a screw (9). � Drill two holes � 8mm on the upper side close to the ceilling (10), fit two wall plugs and fix the chimney support with two screws (11). In case the hood is to be used in filter version, mount the deflector F on the chimney support with four screws 2,9x6,5 and fit a vent hose (12 - Not supplied - must be purchased) to connect deflector to the outlet hole D of the hood. In case the hood is to be used in extraction mode, then the deflector must not be mounted and fit a vent hose (12 - Not supplied - must be purchased) to connect outlet hole D of the hood to the outside. � Make electrical connection (13), but leave the hood disconnected from the main circuit board. � Insert the vapour screen (Not supplied - must be purchased - see Special Accessories and page 17 on the motor housing and fix it with four screws M4x35 (14). � Fix the chimney first up (15a) to the chimney support (15b), then on the bottom (16a) to the upper side of the frame (16b) using four screws 2,9x6,5. � Connect the hood the the main circuit board and check if the hood works properly.
