|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
 ;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
;
The service manual was complete and the components on the drawings very good visible.
;
downloaded next day , manual is very helpful , fast and easy
;
This Service Manual was exactly what I needed to repair my Philips TV. The purchase was convenient and I received the manual at the same day I paid for it.
8.4.
Disassembly Procedure for the Lens
4. Turn the drive gear to the indicated by arrow fully.
NOTE: When Disassembling and Assembling for the Lens 1. To minimize the possibility of the CCD being dirt, perform disassemble and/or assemble under the condition of the CCD is being mounted. Disassembling procedures for the CCD unit, refer to item 8.6. 2. Take care that the dust and dirt are not entered into the lens. In case of the dust is putted on the lens, blow off them by airbrush. 3. Do not touch the surface of lens. 4. Use lens cleaning KIT (BK)(VFK1900BK). 5. Apply the grease (VFK1829) to the point where is shown to" Grease apply" in the figure. When the grease is applied, use a toothpick and apply thinly. 6. When repair the fixed frame, drive frame and direct frame, must be unit exchange.
8.4.1.
Zoom Motor Unit, Master Frange Unit and 1st Lens Frame/2nd Lens Frame Move Unit
1. Unscrew the 4 screws (A). 2. Remove the zoom motor unit to the indicated by arrow. 3. Move the master frange unit to the indicated by arrow.
5. Push the 1st lens frame unit to the indicated by arrow from lens side, and then remove the unit of 1st lens frame/2nd lens frame move unit from the fixed/drive/direct frame unit.
25
|
|
|
> |
|
