|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
3.4.2.
INITIAL SETTINGS:
When you replace the Main PCB, be sure to perform the initial settings after achieving the adjustment by ordering the following procedure in accordance with model suffix of the unit. 1. IMPORTANT NOTICE: Before proceeding Initial settings, be sure to read the following CAUTIONS.
2. PROCEDURES: � Precautions: Proceed the picture back up from the unit. (Refer to above "CAUTION 2") � Preparation. Set the Recording mode to "[ P ] Program AE mode". Set the [REC]/[PLAYBACK] selector switch to �[ REC ] (Red camera mark)�. Turn on the power and then press the [MODE] button. Select the "[ P ] Program AE mode" using "Touch panel". Turn the power off. � Step 1. The temporary cancellation of initial setting: Set the [REC]/[PLAYBACK] selector switch to �[ REC ] (Red camera mark)�. While keep pressing [ DISPLAY ] and �[ UP ] of Joystick� simultaneously, turn the Power on. � Step 2. The cancellation of initial setting: Set the [REC]/[PLAYBACK] selector switch to �[ PALYBACK ]�. Press [ DISPLAY ] and �[ UP ] of Joystick� simultaneously, then turn the Power off. � Step 3. Turn the Power on: Set the [REC]/[PLAYBACK] selector switch to �[ REC ] (Red camera mark)�, and then turn the Power on. � Step 4. Display the INITIAL SETTING: While keep pressing �[ RIGHT ] of Joystick� simultaneously, turn the Power off.
10
|
|
|
> |
|
