|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
Recording images (basic)
3
3
: Forced OFF When you do not open the flash, this mode is set. Even in dark places, the flash does not fire. Set it when you take pictures in places where using flash is not allowed. In this time, the shutter speed is set between 1/8th and 1/2000th. (except in night portrait mode [ ])
To close the flash
Press in the direction of the arrow until it clicks. � Be sure to close the flash when you do not use it.
� Do not stare at the flash light from close proximity when using the flash. � If you bring the flash too close to the subjects, they may be distorted or discolored by its heat and lighting. � The available flash range is about 0.98 feet (30 cm) � 6.89 feet (2.1 m). (When setting to ISO100) � If the subject is too close when using the flash, the image may be over exposed. � When the jitter alert is displayed within the available flash range, we recommend using the flash. � Do not cover the flash sensor 1 with your finger or any other item. Otherwise the picture will not be exposed properly. Similarly, do not cover the flash light. � In motion image mode [ ] or when the flash is closed, flash setting is fixed to the Forced OFF [ ]. � When you set to burst mode or auto bracket, only 1 picture is taken for every flash firing. � In night portrait mode [ ], setting is fixed to Slow sync./Red-eye reduction [ ]. � When you are using the flash, we recommend removing the lens hood. In some case it my not allow the scene to be illuminated properly. � The flash indication becomes red when pressing the shutter button halfway. � When the flash is being charged, the flash indication blinks red, and you cannot take a picture even when you press the shutter button fully. � Be sure to open the flash entirely when using the flash. � When taking a picture with the flash, the white balance will be automatically adjusted (only when in [AUTO] or halogen mode [ ]), but the white balance may not be properly adjusted when the flash light is insufficient. � When taking a picture with the flash after setting the white balance manually, the white balance may not be properly adjusted. We recommend setting the white balance to [AUTO] when using the flash. (P58)
37
|
|
|
> |
|
