|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
DMC-L1KPP / DMC-L1KEB / DMC-L1KEG / DMC-L1KGC / DMC-L1KGK / DMC-L1KGN / DMC-L1KGT
1.2.2.
INITIAL SETTINGS:
When you replace the Main PCB be sure to perform the initial settings after achieving the Adjustment, by ordering the following procedure in accordance with model suffix. · Step 1. The temporary cancellation of factory setting: Set the shutter speed dial to � 8 �. While keep pressing AFL/AEL Press the � Playback Press FUNC.2 , then turn the Power on. · Step 2. The cancellation of factory setting: � button to playback mode. and � UP of Cursor key� simultaneously, then turn the Power off.
· Step 3. Turn the Power on: Set the shutter speed dial to � A �, and then turn the Power on. · Step 4. Display the INITIAL SETTING: 1. Press the Playback button, and then viewing information display. and � RIGHT of Cursor key� simultaneously, turn the Power off. 2. While keep pressing MENU/SET
· Step 5. Set the INITIAL SETTING: Select the area with pressing � UP / DOWN of Cursor key�, and then press the � RIGHT of Cursor key�.
The only set area is displayed, and then press the � RIGHT (The unit is powered off automatically.)
of Cursor key� after confirmation.
4
|
|
|
> |
|
