|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
3.4.2.
INITIAL SETTINGS:
When you replace the Main PCB, be sure to perform the initial settings after achieving the adjustment by ordering the following procedure in accordance with model suffix of the unit. 1. IMPORTANT NOTICE: Before proceeding Initial settings, be sure to read the following CAUTIONS.
2. PROCEDURES: � Precautions: Proceed the picture back up from the unit. (Refer to above "CAUTION 2") � Preparation. Set the Recording mode to "Normal Picture Mode". Set the Recording/playback switch to �[ Recording mode ] (camera mark Turn on the power and then press the [MODE] button. Select the �NORMAL PICTURE MODE" using �[ UP ] / [ DOWN ] Press [ MENU/SET ] button, then turn the power off. � Step 1. The temporary cancellation of initial setting: (UP))�.
of Cursor button�.
Set the Recording/playback switch to �[ Recording mode ] (camera mark
(UP))�.
While keep pressing [ E.ZOOM ], [ MENU ] and �[ UP ] of Cursor button� simultaneously, turn the Power on. � Step 2. The cancellation of initial setting: Set the Recording/playback switch to �[ Playback (Down) ]�. Press [ E.ZOOM ], [ MENU ] and �[ UP ] � Step 3. Turn the Power on: of Cursor button� simultaneously, then turn the Power off. (UP))�, and then turn the Power on.
Set the Recording/playback switch to �[ Recording mode ] (camera mark � Step 4. Display the INITIAL SETTING: While keep pressing [ MENU ] and �[ RIGHT ]
of Cursor button� simultaneously, turn the Power off.
8
|
|
|
> |
|
