|
Who's Online
There currently are 5795 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
8.4.
Disassembly Procedure for the Lens
NOTE: When Disassembling and Assembling for the Lens 1. To prevent the lens from catching the dust and dirt, perform the following procedures with the CCD unit is installing. Disassembling procedures for the CCD unit, refer to item 8.6. 2. Take care that the dust and dirt are not entered into the lens. In case of the dust is putted on the lens, blow off them by airbrush. 3. Do not touch the surface of lens. 4. Use lens cleaning KIT (BK)(VFK1900BK). 5. Apply the grease (VFK1829) to the point where is shown to" Grease apply" in the figure. When the grease is applied, use a toothpick and apply thinly.
8.4.1.
1. 2. 3. 4. 5.
Removal of the Zoom Motor Unit and Master Flange Unit
Remove the solders (2 points). Remove the lock (4 points). Unscrew the 5 screws (A). Remove the Zoom Motor Unit to the indicated by arrow. Remove the master flange unit.
Fig. D14
NOTE: (When Assembling) Confirm the contents as shown below. � Condition of the screw is tightened. � Assembling condition of mechanism parts (distortion, space etc.) � Dust and dirt of the lens, display condition of the LCD (gradient etc.) � Dust and dirt of the LCD
29
|
|
|
> |
|