|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
 ;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
8.4.
Disassembly Procedure for the Lens
NOTE: When Disassembling and Assembling for the Lens 1. To prevent the lens from catching the dust and dirt, perform the following procedures with the CCD unit is installing. Disassembling procedures for the CCD unit, refer to item 8.6. 2. Take care that the dust and dirt are not entered into the lens. In case of the dust is putted on the lens, blow off them by airbrush. 3. Do not touch the surface of lens. 4. Use lens cleaning KIT (BK)(VFK1900BK). 5. Apply the grease (VFK1829) to the point where is shown to" Grease apply" in the figure. When the grease is applied, use a toothpick and apply thinly.
8.4.1.
1. 2. 3. 4. 5.
Removal of the Zoom Motor Unit and Master Flange Unit
Remove the solders (2 points). Remove the lock (4 points). Unscrew the 5 screws (A). Remove the Zoom Motor Unit to the indicated by arrow. Remove the master flange unit.
Fig. D14
NOTE: (When Assembling) Confirm the contents as shown below. � Condition of the screw is tightened. � Assembling condition of mechanism parts (distortion, space etc.) � Dust and dirt of the lens, display condition of the LCD (gradient etc.) � Dust and dirt of the LCD
29
|
|
|
> |
|
