|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
;
Great deal, you are the only one on earth who could deliver this old manual. Thx so much and have nice chrismas
;
Everything is OK. Owner's Manual I downloaded ( I get link for it by email).
ENGLISH
Splice
� Use this function to skip a section between A and B points. The A point is the point from which jumping starts, the B point the point at which jumping ends. � The A1 and A2 Hot Starts and Stutter functions cannot be used if both Splice points are set in the Splice mode.
t
w, r, t e
q
Splice point setting mode
A / B TRIM
Start splice playback
1
q Push the SPLICE button for more than 1 sec to enable setting Splice point using A1, A2 and B buttons.
4
SPLICE
Start playback from any point before point A. When point A is reached, the section from point A to point B is jumped seamlessly and playback continues. Temporarily turning off the splice playback r When the corresponding A button is pushed after setting splice points A and B, the A button illumination turns off and the Splice play mode is temporarily turned off. � Push the corresponding A button again to resume splice playback. Clearing the splice points t While pressing the FLIP/(CLR) button, push the corresponding A button to clear splice points A and B.
� The A button illumination flashes when the Splice mode is set. � The Splice point setting cannot be set for the A point at which Hot Start data is already loaded. Set splice start point A w After starting playback, push the A1 or A2 button. The corresponding A button lights up and that point is set as splice start point A, and B LED start flashing. Set splice end point B
5
2
3
e After setting splice start point A, push the B button. The B LED lights up and that point is set as splice end point B.
6
� When the splice points are cleared, the A button is set back to the Hot Start mode.
17
|
|
|
> |
|
