|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
4
Holding down the DMC MODE button, turn the search dial, to set the initial speed at the playback start point. The speed you set appears in the time counter. During this period the tape does not move. When the initial speed setting is complete, release the DMC MODE button.
4-3-3 Executing DMC Playback
There are two methods of starting DMC playback. � Starting playback at the on-air cue from the on-air start point � Starting playback immediately after preroll
Note
5
Press the LEARN button. The tape is prerolled and played back at normal speed from the on-air start point to the speed variation start point. On passing the speed variation start point, the MEMORY indicator begins to flash, and playback begins at the speed set in step 4.
To avoid operating mistakes we recommend that you use the unit in standalone mode when carrying out DMC playback.
%
6
Turn the search dial to vary the playback speed. While the MEMORY indicator is flashing, the speed variations are stored in memory. On passing the speed variation end point, the MEMORY indicator changes from flashing to continuously lit, and the variable speed storing ends.
6
0
9
)
p
1,2
To start playback at the on-air cue from the on-air start point Use the following procedure.
7
Press the STOP button to stop the tape.
If the MEMORY indicator lights continuously before the speed variation end point This indicates that the memory became full at that point. It is therefore not possible to record more speed variation. The maximum capacity is a duration of 120 seconds. To amend the stored speed variation Press the LEARN button. The interval between the speed variation start and end points is automatically played back at the stored speed. Operate the search dial as required, to adjust the playback speed. Setting the initial speed to normal speed In step 4, press the PLAY button.
1
Press the CUE/PLAY button. The CUE/PLAY button lights, and the tape is cued up to the on-air start point. After the tape is cued up, the CUE/PLAY button flashes.
2 At the moment the on-air cue is given, press the
CUE/PLAY button once more. The CUE/PLAY button lights, and playback starts at standard speed. Between the speed variation start and end points, DMC playback is carried out at the stored speed, and then playback continues at normal speed and the tape stops at the on-air end point.
Chapter 4 Playback
Chapter 4
Playback
4-7
 $4.99 DNW-65P SONY
Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|
