TEAC DP-01FX
Quick Start

Using the Reverb Effect (DP-01FX)

T

he DP-01FX has a dedicated Reverb effect that�s available to all tracks. Each channel has an Ef-

fect Send knob so that you can control the amount of reverb � lots of reverb for the drums, a little on the vocal, etc. Here�s how you set that up. 1. If the REVERB light is not on, hold the SHIFT button and press REVERB. 2. Let go of the SHIFT button and press REVERB again. The LCD window will show you what reverb type is selected.

3. Turn the TYPE knob to change to a different reverb type: Hall, Room, Live or Studio. 4. Turn the PARAMETER knob to change the decay time of the reverb for a larger or smaller-sounding space. 5. Send your recorded tracks to the reverb processor using the EFFECT SEND knobs above those channel faders and adjust the overall level of the external effect using the EFFECT RETURN knob.

Using External Effects

I

f you have a reverb or multieffects processor, you can plug it into the DP-01 to use in your mix.

5 6

1. Plug the SEND on the rear panel of the DP-01 into the input of your effects processor. 2. Plug the outputs of your effects processor into the RETURN inputs of the DP-01. 3. Set the Mix control on your effects processor to 100% wet. 4. [DP-01FX only] Turn off the internal reverb processor by holding the SHIFT button and pressing the REVERB button (the light will go out). 5. Send your recorded tracks to the effects processor using the EFFECT SEND knobs above those channel faders. 6. You can adjust the overall level of the external effect using the EFFECT RETURN knob.

4

Using the Multi Effect (DP-01FX)

T

he DP-01FX has two effects processors. The Multi effect processes the input as it�s recorded

to disk, while the Reverb effect is only for the mixdown and only gets recorded when you master your song. This section explains how to use the Multi: 1. Plug a guitar or other sound source into one of the front-panel inputs. 2. Set the INPUT MODE switch on the front panel to MONO. 3. While holding SHIFT, press the MULTI button. The LED next to the button will show whether

the effect is processing the A input, B input or neither one. 4. Let go of the SHIFT button and press MULTI again. The LCD screen will show you what effect program is selected. The �rst line shows the name of the program (�CoolPick�), and the second line shows what instrument it�s designed for (�EGTR�). 5. Turn the TYPE knob to change to a different effect program. 6. Turn the PARAMETER knob to change the sound of that program.

03/01/05

Page 2 of 4

DP-01 / DP-01FX

Quick Start Guide