|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
standby. Note: This is the size adjustment and do not worry about the positioning.
DP-2310/3010 DP-2330/3030
2.8.7.
ADF Original Read Edge & ADF Main Scan Adjustments
1. Place the Original Document on the ADF. 2. Insert Ledger or A3 size paper into the 1st tray and change the tray setting to the appropriate paper size. Empty or pull out all the remaining trays (including the bypass tray) to disable them. 3. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that order to enter the Service Mode. 4. Perform the Service Mode F2 (Single Copy Test). 5. Check the Image size of the Copy and the Original as Portrait. 6. Perform the Service Mode F6-91 (Original Read Edge ADF), to adjust the ADF Original Read Edge. 7. If the gap is less than the Original, input a (+) value. If bigger than the Original, input a (-) value. 8. Perform the Service Mode F6-90 (ADF Read Main Scan Pos.), to adjust the ADF Main Scan for Side position. 9. If the gap is less than the Original, input a (+) value. If bigger than the Original, input a (-) value. 10. Press "STOP" first and then press "FUNCTION" + "CLEAR" keys simultaneously to return to standby.
2.9.
Calibrating the LCD
1. Turn the Main Power Switch on the Back of the machine to the OFF (O) position and leave the Power Switch on the Left Side of the machine in the ON (I) position. 2. Ensure that the F-ROM Card with Firmware Update is not installed in the machine. If the Card is installed in the machine, remove it. 3. Press and hold the "ENERGY SAVER" and "FUNCTION" keys down simultaneously, then turn the Main Power Switch on the Back of the machine to the ON (I) position and continue holding the keys for approximately 30 seconds until the Display becomes stable. The LCD Display starts blinking and shows a "+" on the upper left edge of the display. Note: If you do not hold the "ENERGY SAVER" and "FUNCTION" keys down long enough, the Display may go OFF. 4. Press the "+" on the upper left edge of the display, press the "+" on the lower right edge and press the "+" on the center of the display. Then the display goes to stand-by. Caution: Prevent any damage to the LCD Display by not pressing with Sharp Edged Objects such as a Ball Point Pen, etc. 5. Reboot the machine by cycling the power. Turn the Main Power Switch on the Back of the machine to the OFF (O) then ON (I) position.
53
Ver. 2.0 DEC 2004
|
|
|
> |
|
