|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Option Selector Switch
Before starting
your dishwasher
3. Run hot water at sink nearest dishwasher until it is hot. Turn it off. (See page 10 for connecting instructions.)
1. Spin the Upper Spray Arm to make sure nothing will stop it from turning freely. 2. Close and latch the door.
Starting
your dishwasher
NORMAL HEAVY Cycle...
1. Make sure Cycle Control Knob points to dot marked NORMAL HEAVY. 2. Select option. 3. Without turning it, pull the Cycle Control Knob out to start the Cycle.
NORMAL
LIGHT Cycle...
RINSE & HOLD Cycle...
1. Select
Control Knob until it stops at dot marked NORMAL LIGHT. 2. Select option. 3. Without turning it, pull the Cycle Control Knob out to start the Cycle.
1. Turn Cycle
2. 3. 4. 5.
AIR DRY Option only. Uniatch door and open slightly. Pull Cycle Control Knob out. Turn Control Knob clockwise to dot marked RINSE & HOLD. Close and latch the door to start the cycle.
Control Knob
Changing
a setting
during
2. With the Cycle
pulled
out,
You can change a setting anytime any cycle. 1. Unlatch the door to stop the cycle.
turn clockwise to the cycle you want. 3. Be sure the detergent dispensers are filled properly for the new cycle. 4. Latch the door to start the cycle.
|
|
|
> |
|
