|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm very happy that you all are performing an incredible good job. Furthermore what you did is very useful for all people as me that have electronics as an hobby.Thank you!!!!!
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
(Example) Assume that the first display is (R2-4) and that the difference between the display and head resistance value is 350 Z (the resistance value of a new head is higher). The display after replacement is (R35). (Since the difference the display and head resistance value is 290 Z or more, the step of R automatically increase by one step. The step of a numeric character also increases by one step because of 350 _ 290 = 60. For the step of a numeric character, the width of one step is approximately 73 Z. Therefore, the step of the numeric character increases or decreases by one step if the difference is 36 to 37 Z or more.) 9. Move a \ mark using Direction keys so that it is located in Rx (x = 1 to 8) obtained by the difference between the display and head resistance value. (In Fig. 3-7, a \ mark is located in R3.) Press the Print key when the \ mark is moved to the determined �Rx� position. 10. Printing is initiated and the screen (shown in Fig. 3-8) is displayed on the monitor screen.
Fig.3-7
Fig.3-8
11. After the printing is completed, move the \ mark to the determined numeric character (�5� because of (R3-5) in this example) using Direction keys and press the Enter key. (Fig. 3-9)
Fig.3-9
DPP-SV88 V1
3-5
|
|
|
> |
|
