|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
;
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
 ;
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
;
Quick response and exactly what I was looking for and at a great fair price!
;
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Chapter 13: Using the effects
iTIP : If you selected Global effects for both EFFECT A and B, you may want to select
STEREO
1 MIXED
or 2 STEREO PAIRS If you have selected Insert effects for either EFFECT A or B or PAIRS. both, you may want to select 2 STEREO PAIRS PAIRS.
Routing effect return signals to THRU MIX channels
You can send effect return signals that have been switched as analog input signals to the THRU MIX channels in the mixer section to mix them with the TRACK MIX channel signals (track playback). Follow the steps below to send the effect return signals to the mixer section. 1. Press the THRU [F2] key in Assign mode. 2. Select the analog inputs to which the effect return signals are routed, and select as their destination.
THRU MIX
Example: If you selected
2 STEREO PAIRS in Assign FXB RTN-L FXB RTN-R to THRU MIX RTN-L, RTN-R, MIX.
mode, route
FXA RTN-L FXA RTN-R RTN-L, RTN-R,
Setting the effect send level
You may set the AUX send level of the TRACK MIX channels to which you wish to apply effects in Mixer mode. The operation will differ slightly depending on whether you selected Global effects or Insert effects.
s If you selected Global effects
1. Select TRACK MIX channels in Mixer mode, and adjust the AUX SEND-A or AUX SEND-B level of the channel to which you wish to apply effects. AUX SEND A signal is sent to EFFECT A, and AUX SEND B signal is sent to EFFECT B. At this time, you can check the output level of AUX SENDs A/B using level meters SA/B. If the level is too high, adjust it using the channel SEND MASTER and AUX SEND-A/B parameters.
1
You can check the output level of AUX SEND A/B using the meter 1. 2. Recall the AUX-A PRE/POST and AUX-B PRE/POST parameters to select whether the signals sent to EFFECT A/B are routed from the pre-fader or post fader.
132
|
|
|
> |
|
