ONKYO DPS6.5
Owner's Manual

Before Using the DPS-6.5
Installing the Batteries Using the Remote Controller
To use the remote controller, point it at the DPS-6.5�s remote control sensor, as shown below.
Remote control sensor DPS-6.5
Standb y/On
Progressiv

1

Open the battery compartment, as shown.

Standby

e

Display Play Mode

Dimmer Clear

Open

/Close Pause Stop Play

DPS-6.5

2

Insert the two supplied batteries (AA) in accordance with the polarity diagram inside the battery compartment.

30�

30�
ppr ox .

16

ft

. (5

m

)

A

3

Close the battery compartment.

Notes: � The supplied batteries should last for about six months, although this will vary with usage. � If the remote controller doesn�t work reliably, try replacing both batteries. � Don�t mix new and old batteries, or different types of batteries. � If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion. � Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion.

Notes: � The remote controller may not work reliably if the DPS-6.5 is subjected to bright light, such as direct sunlight or inverter-type �uorescent lights. Keep this in mind when installing the DPS-6.5. � If another remote controller of the same type is used in the same room, or the DPS-6.5 is installed close to equipment that uses infrared rays, the remote controller may not work reliably. � Don�t put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. � The remote controller may not work reliably if the DPS-6.5 is installed in a rack behind colored glass doors. Keep this in mind when installing the DPS-6.5. � The remote controller will not work if there�s an obstacle between it and the DPS-6.5�s remote control sensor.

11